QuinLED Resistor Switcher Back to Addressable LEDs section During the 2022 revision updates of the QuinLED Dig-Uno, Dig-Quad and on the initial version of the Dig-Octa and Data-Booster a resistor switcher functionality was added to the boards. These resistor-switchers allow you to switch between a 249R and 33R output resistor, this helps adapt the data […]
QuinLED Resistor Switcher During the 2022 revision updates of the QuinLED Dig-Uno, Dig-Quad and on the initial version of the Dig-Octa and Data-Booster a resistor switcher functionality was added to the boards. These resistor-switchers allow you to switch between a 249R and 33R output resistor, this helps adapt the data signal to the type of […]
Data Signal Cable Conditioning
Uncategorized
Data Signal Cable Conditioning Back to index page 2023-2025 update Since v3.1 of the pre-assembled Dig-Uno and Dig-Quad they have a selectable resistor switcher circuit built-in (33R and 249R) so a data-booster right behind the Dig board is not needed anymore. The Dig-Octa System also had this functionality included right from the start! The data-booster […]
Maximum length data wire LEDs (2022-12 update!) Back to article index This whole article talks about the data wire length from the controller to the first LED, going from LED and LED below does not apply! From LED to LED the signal is much less powerful then from a (QuinLED-Dig) controller. A different solution should […]