QuinLED Diff-Adv specifications

Back to QuinLED-Diff-Adv main page

The QuinLED Diff-Adv System consists of multiple boards, this article is specifically about the QuinLED Diff-Adv Sender-4. The function of this board is to take in up to 4 LED data signals (like a Dig-Uno, Dig-Quad or Dig-Octa System) and transform it into a differential signal over a UTP cable that can reach up to 500m/1800ft.

For the pinout used on the RJ45 side, please see this article.

QuinLED Diff-Adv Sender-4

• Color: White
• Input Screw terminals
  • 6p 5.08mm “rising clamp”
    • Supports up to 14AWG with wire ferrule
  • VCC
  • GND
  • 4xData
• Differential output
  • RJ45 socket with lip on top side
  • Pinout for the RS-485 communication lines can be found here

• Supported board input voltage through screw terminals
  • 5v-48v (auto input)
• Board Power usage
  • ~400mA at 5v
  • ~250mA at 12v
  • ~150mA at 24v
  • ~75mA at 48v
• Data voltage required
  • 3.3v or 5v signal levels supported
• RS-485 Termination resistors
  • Permanently in place on the board
  • Includes RJ45 pluggable terminator to use at end of daisy chain of Receiver-Midpoint boards

• Mounting holes
  • 4x M3