QuinLED-An-Penta DIY Board Dimensions

Back to QuinLED-An-Penta-DIY index page

For the people wanting to integrate the QuinLED-An-Penta into a (3D printable) case or enclosure, see the picture below the for the exact measurements of the board. You need to take about 3,5CM of height into account without Ethernet, if there is a QuinLED-ESP32-ABE (Ethernet) on there, the height is about 3cm higher so 6cm in total.

QuinLED-An-Penta uses M3 screw holes.

If you are looking to use a closed box, this is possible but please limit the amount of Amps running through the board. If you want to use the specified values (up to 20A) a vented enclosure is highly recommended!