QuinLED An-Penta-Mini Pinout Guide
Back to QuinLED An-Penta-Mini Index
To be able to configure the QuinLED-An-Mini in your software of choice (like WLED or ESPhome) you are going to need to know what is connected to what pins. In the below table you can see exactly how all the hardware is connected internally.
GPIO | Board | Use |
---|---|---|
GPIO_2 | Button_1 | Button/Switch/Sensor connection (Pulled High, HW Debounce) |
GPIO_8 | Button_2 | Button/Switch/Sensor connection (Pulled High, HW Debounce) |
GPIO_9 | Button_3 | Button/Switch/Sensor connection (Pulled High, HW Debounce) |
(Can also be used to forceboard into bootloader mode if connected to GND) | ||
GPIO_6 | I²C SDA | External I²C connections using Stemma QT/Qwiic connector |
GPIO_7 | I²C SCL | External I²C connections using Stemma QT/Qwiic connector |
GPIO_5 | L1 | LED_1 PWM Output (CW) |
GPIO_4 | L2 | LED_2 PWM Output (WW) |
GPIO_1 | L3 | LED_3 PWM Output (B) |
GPIO_0 | L4 | LED_4 PWM Output (G) |
GPIO_3 | L5 | LED_5 PWM Output (R) |
Product shots