QuinLED-An-Penta DIY Pinout Guide
Back to QuinLED-An-Penta-DIY index page
QuinLED-An-Penta v1r2 – Power Terminals
A description of the power terminals available on the board.
Please make sure power supply and input voltage match voltage LEDs need!
| Board | Use |
|---|---|
| ++ | 12v - 36v DC Positive Power Supply Input |
| GND | 12v - 36v DC Negative Power Supply Input |
| F1 | Power run through Fuse 1 |
| F2 | Power run through Fuse 2 |
| Terminal - 5v | 5v output, max 500mA |
| Terminal - GND | GND output |
| Terminal - 3v3 | 3.3v output, max 500mA |
| Terminal - GND | GND output |
QuinLED-An-Penta v1r2 – Logical pinout
A description of all available logical port and terminals on the board.
The GPIO_ESP32 number is what you use in ESPhome or WLED!
| GPIO_ESP32 | Board | Use |
|---|---|---|
| GPIO14 | L1 | LED output 1 |
| GPIO13 | L2 | LED output 2 |
| GPIO12 | L3 | LED output 3 |
| GPIO_4 | L4 | LED output 4 |
| GPIO_2 | L5 | LED output 5 |
| GPIO34 | S1 | Switch input (read-only, pulled high, HW debounced) |
| GPIO35 | S2 | Switch input (read-only, pulled high, HW debounced) |
| GPIO39 | S3 | Switch input (read-only, pulled high, HW debounced) |
| GPIO_1 | I2C SDA | I2C for Temp sensor and broken out terminals |
| GPIO_3 | I2C SCL | I2C for Temp sensor and broken out terminals |
| IO_0 | Terminal | Extra GPIO (pulled high, needs to be high during boot!) |
| GPIO21* | Terminal | Extra GPIO (*Cannot be used with Ethernet) |
| GPIO22* | Terminal | Extra GPIO (*Cannot be used with Ethernet) |
| GPIO15 | SPI OLED CLK | Pin for OLED or extra GPIO |
| GPIO16 | SPI OLED MOSI | Pin for OLED or extra GPIO |
| GPIO33 | SPI OLED RESET | Pin for OLED or extra GPIO |
| GPIO32 | SPI OLED DC | Pin for OLED or extra GPIO |
| GPIO27* | SPI OLED CS | Pin for OLED or extra GPIO (*Cannot be used with Ethernet) |
QuinLED-ESP32-ABE (Ethernet pins)
If you are using the QuinLED-ESP32-ABE (Ethernet) a lot more pins get used!
| GPIO_ESP32 | Use |
|---|---|
| GPIO_5 | Power IC Enable trigger (3.3v High for On) |
| GPIO17 | Clock Signal (from ESP32) |
| GPIO18 | Ethernet (PHY_MDIO) |
| GPIO19 | Ethernet (TXD[0]) |
| GPIO21 | Ethernet (TX_EN) |
| GPIO22 | Ethernet (TXD[1]) |
| GPIO23 | Ethernet (PHY_MDC) |
| GPIO25 | Ethernet (RXD[0]) |
| GPIO26 | Ethernet (RXD[1]) |
| GPIO27 | Ethernet (CRS_DV) |