QuinLED Resistor Switcher During the 2022 revision updates of the QuinLED Dig-Uno, Dig-Quad and on the initial version of the Dig-Octa and Data-Booster a resistor switcher functionality was added to the boards. These resistor-switchers allow you to switch between a 249R and 33R output resistor, this helps adapt the data signal to the type of […]
Can you run LEDs over POE? Back to article index TL;DR Yes, in a limited capacity it turns out you actually can! Video at the end of the article! Ever since I’ve starting talking about the custom QuinLED-ESP-ABE (Antenna Board + Ethernet) and especially running a QuinLED-Dig-Uno or QuinLED-Dig-Quad together with one of those making […]
What is the max amount of Addressable LEDs per controller? Back to article index I often see this question pass by in the Discord server and online, how many LEDs can controller X handle? And well, it’s true, cannot keep adding more LEDs to a digitally addressable LED strip/string and get the same results, after […]
WLED 0.12 What do I configure for QuinLED WLED 0.13.1 is already available too, functionality and configuration stays the same! WLED 0.12.0 was released today and with it comes full multi-channel LED strip support and in GUI configurable pinout! This makes it so that most users will never have to do a custom compile again […]
Maximum length data wire LEDs (2022-12 update!) Back to article index This whole article talks about the data wire length from the controller to the first LED, going from LED and LED below does not apply! From LED to LED the signal is much less powerful then from a (QuinLED-Dig) controller. A different solution should […]