Dig-Next-2
Multi-Relay Guide
The Dig-Next-2 has 3 internal DC positive side relays and also a dedicated port to connect an external relay to switch off your main power supply on the AC side. Thi is however more then the 1 relay WLED supports by default, to overcome that limitation the Dig-Next-2 uses a usermod called “Multi-Relay” which allows you to configure extra relays! This usermod is compiled in and configured by default if you install the firmware from https://install.quinled.info!
It’s important to have these relays configured, without it there will be no output power from the Dig-Next-2!
The GPIO pins are as follows:
- GPIO5 = External Relay 5V trigger output (yellow cable)
- GPIO20 = 5A_1 On/Off Internal DC relay
- GPIO21 = 10A_1 On/Off Internal DC relay
- GPIO22 = 5A_2 On/Off Internal DC relay
This then looks like the following in settings -> usermods:
