QuinLED-Diff-Solo Revision History
Back to QuinLED-Diff-Solo main page
This document will keep track of changes over time when I change the board design over time. Either because of improvements, components that are out of stock or raised prices, etc.
QuinLED-Diff-Solo
Sender
- Initial Release (2024-03-01)
- Initial batch had a few issues which will be corrected in a future batch
- RJ45 connector is black, future revisions will use yellow to differentiate vs an Ethernet connection
- RS485 chip used was the wrong type, future revision will use a different chip with 2 changes
- Higher ESD resistance
- Higher Data Rate (10Mbps vs 2.5Mbps)
- These issues have little to no impact on normal functionality
- Initial batch had a few issues which will be corrected in a future batch
QuinLED-Diff-Solo
Receiver
- Initial Release (2024-03-01)
- Initial batch had a few issues which will be corrected in a future batch
- RJ45 connector is black, future revisions will use yellow to differentiate vs an Ethernet connection
- RS485 chip used was the wrong type, future revision will use a different chip with 2 changes
- Higher ESD resistance
- Higher Data Rate (10Mbps vs 2.5Mbps)
- These issues have little to no impact on normal functionality
- Initial batch had a few issues which will be corrected in a future batch