Uncategorized
Data Signal Cable Conditioning Back to index page 2023-2025 update Since v3.1 of the pre-assembled Dig-Uno and Dig-Quad they have a selectable resistor switcher circuit built-in (33R and 249R) so a data-booster right behind the Dig board is not needed anymore. The Dig-Octa System also had this functionality included right from the start! The data-booster […]
QuinLED-Dig-Uno Pre-Assembled boards available! Back to index page Current version v3.5r3 Don’t know what a QuinLED-Dig-Uno is? Click here for the introduction video! Are you looking to run the excellent WLED software but don’t want to cobble together an ESP8266 with some loose wires, do the soldering or maybe want a bit safer setup? The […]
QuinLED-Dig-Quad Pinout Guide Back to index page QuinLED-Dig-Quad v2 and v3 If you are looking for the QuinLED-Dig-Quad v1 pinout guide, please go here The GPIO_ESP32 number is what you use in WLED! *Q1R pin available only on pre-assembled version! LED1, LED2, LED3, LED4 and Q1R are only usable as outputs since the Level Shifter […]
Can you run LEDs over POE? Back to article index TL;DR Yes, in a limited capacity it turns out you actually can! Video at the end of the article! Ever since I’ve starting talking about the custom QuinLED-ESP-ABE (Antenna Board + Ethernet) and especially running a QuinLED-Dig-Uno or QuinLED-Dig-Quad together with one of those making […]
QuinLED-Dig-Quad Board Dimensions This article applies to v2 boards, please see here for v1 dimensions! For the people wanting to integrate the QuinLED-Dig-Quad v2 into a case or make a 3D printed design for it, see the picture below the for the exact measurements of the board. You need to take about 3,5CM of height […]