QuinLED-dig2analog Suggested configuration in WLED Back to index page To configure the dig2analog in WLED you set the following details on your Dig-Uno, Dig-Quad or Dig-Octa digitally addressable controller. * The dig2analog expects a 5v data signal, a direct 3.3v signal from an ESP32 board might or might not work WLED – LED preferences It’s […]
QuinLED dig2analog Power Handling Back to index page The dig2analog is designed towards using lots of boards with a smal LED strips connected to each of them. With that said however it’s still quite capable with a max output of 3A by default and upgradable to 6A by the end user (read more about that […]
QuinLED dig2analog specifications Back to index page The dig2analog is based on the WorldSemi WS2814F chip. This chip is used to “extract” the data for a single LED/Pixel and the board converts it to a PWM output able to drive 12v or 24v LED strips up to RGBW. The onboard circuitry has been carefully tuned […]
QuinLED dig2analog Back to Addressable LEDs section 2023-11-21 Boards are available for purchase! The dig2analog is based on the WorldSemi WS2814F chip. This chip is used to “extract” the data for a single digital LED/Pixel and the board converts it to a PWM output able to drive Dumb/Analog 12v or 24v LED strips with PWM […]
To try and keep track of past revisions and the major changes between the versions here is a list of past releases and some of the things that have changed. QuinLED-ESP32 Version 1 Revision 2 2021-03 Initial release version Revision 3 2021-07 Changed EN capacitor to higher value for better chance of auto flash mode […]
Tags: