QuinLED Diff-Solo Board Dimensions Back to QuinLED Diff-Solo main page If you want to use the Diff-Solo and want to fit it into a box or screw it down somewhere, you can find all dimensions below. Height is about 2cm, the fuse is the highest element on the board. All screw sizes are M3 and […]

QuinLED Diff-Solo Revision History Back to QuinLED Diff-Solo main page This document will keep track of changes over time when I change the board design over time. Either because of improvements, components that are out of stock or raised prices, etc. QuinLED Diff-Solo Sender Initial Release (2024-03-01) Initial batch had a few issues which will […]

QuinLED-Diff RS-485 wiring Back to QuinLED-Diff section QuinLED-Diff might be compatible with other RS-485 solutions out there, also if you’d want to run other cabling then RJ45 UTP cable it can be useful to understand which signals travel over which wire and pair. Below will be a an explanation of which wires are used how […]

QuinLED Diff-Solo Power Handling Back to QuinLED Diff-Solo main page As for all LED boards, voltage coming in = voltage coming out, match your power supply to be the same voltage your LEDs are running (for the Receiver board). Sender board and Receiver board do not share power and thus can be either the same […]

QuinLED Diff-Solo Back to QuinLED-Diff section The Diff-Solo is meant as a simple to use entry solution for when you need a longer data wire to your LEDs. It’s built down to cost and because of this there are less features then the Diff-Adv series (Future release) that said, it has some great features of […]