QuinLED-Data-Booster Back to Addressable LEDs section Since v3.1 of the pre-assembled Dig-Uno and Dig-Quad they have a selectable resistor switcher circuit built-in (33R and 249R) so a data-booster right behind the Dig board is not needed anymore. The QuinLED-Data-Booster is a little board to solve some common problems around building up a addressable LED setup, […]
QuinLED-Data-Booster Data Signal Conditioning Back to index page QuinLED-Data-Booster(-Maxi) For sale now! One of the main functions of the QuinLED-Data-Booster(-Maxi) is allowing you to select between a 33? ad 249? resistor. All QuinLED-Dig boards come with 249? resistor on board but depending on cabling choice in your setup you might want to change those to […]
QuinLED-Data-Booster(-Maxi) Board Dimensions Back to index page The QuinLED-Data-Booster(-Maxi) is quite small, although this board is called the “Maxi” (there where smaller versions without a screw terminal and switch during development). The board has 3x 5.08mm spaced terminals. The openings for the optional power injection points are M3 screw and nut compatible. For the board […]
QuinLED-Data-Booster for sale Back to index page Data wire lengths and power injection with digitally addressable LEDs is always a much discussed topic. Everyone’s setup is slightly different and optimizing a single digital controller board like the QuinLED-Dig-Uno and QuinLED-Dig-Quad to all situations is basically impossible, because of this I have created the QuinLED-Data-Booster(-Maxi)! QuinLED-Data-Booster(-Maxi) […]
QuinLED-Data-Booster-Maxi Power Injection Back to index page One of the features of the QuinLED-Data-Booster-Maxi is that you can use it for power injection, for this purpose there are 2 M3 sized plated holes on the PCB, one for positive and one for negative. These holes can be used to solder a thick wire directly to […]