QuinLED-dig2analog User Upgrades Back to index page The dig2analog has extra component pads on the back to allow for 2 user upgrades which aren’t installed by default. Extra PTC (Auto Reset) Fuse By default the board is configured with a 3A Auto-Reset fuse. This fuse should suffice for most use cases but if your particular […]
QuinLED-dig2analog Suggested configuration in WLED Back to index page To configure the dig2analog in WLED you set the following details on your Dig-Uno, Dig-Quad or Dig-Octa digitally addressable controller. * The dig2analog expects a 5v data signal, a direct 3.3v signal from an ESP32 board might or might not work WLED – LED preferences It’s […]
QuinLED dig2analog Power Handling Back to index page The dig2analog is designed towards using lots of boards with a smal LED strips connected to each of them. With that said however it’s still quite capable with a max output of 3A by default and upgradable to 6A by the end user (read more about that […]
QuinLED dig2analog specifications Back to index page The dig2analog is based on the WorldSemi WS2814F chip. This chip is used to “extract” the data for a single LED/Pixel and the board converts it to a PWM output able to drive 12v or 24v LED strips up to RGBW. The onboard circuitry has been carefully tuned […]
QuinLED dig2analog Back to Addressable LEDs section 2023-11-21 Boards are available for purchase! The dig2analog is based on the WorldSemi WS2814F chip. This chip is used to “extract” the data for a single digital LED/Pixel and the board converts it to a PWM output able to drive Dumb/Analog 12v or 24v LED strips with PWM […]