QuinLED An-Penta-Plus WLED Guide
Back to QuinLED An-Penta-Plus Index
WLED configurations can vary a lot depending on what you have connected to the board, below are some examples, divided between digital and analog.
Digital configuration
After figuring out the power situation (either direct or using a buck-converter) there are 2 things that need to be configured:
- Set WLED to have a relay on GPIO13
- Configure the LED output channel on GPIO5 to the LED type you have connected
Screenshots of this both on the LED preferences page:
Relay configuration
Digital output, 30x ws2812b
Analog configuration
The analog configuration can be a bit more varied since it really depends on what you are hooking up to the board, here are a few scenarios:
A single RGBCCT strip
A single RGBCCT or RGB+CCT strip consists of 5 channels and can be configured as such.
One single RGBCCT strip (5 channels= Red, Green, Blue + Dual White)
2x Dual-white CCT strips
When used for primary lighting purposes CCT or dual-white strips are a popular choice and 2 of them can be configured on the An-Penta-Plus
2x CCT white strips configured on L1&L2 and L4&L5
5x white LED strip
If you want to run lots of high powered white LED strip the An-Penta-Plus is a great choice! It can be configured as such
