QuinLED An-Penta-Deca Board terminals
Back to QuinLED An-Penta-Deca Index
The QuinLED An-Penta-Deca has various connectors to connect power, your LEDs and even extra button/switches or sensors to the board! Please take a look at the text and below photos for clarification where to hook up what!
[photo of front ports]
[photo of back ports]
Board Terminals
- USB-C connector
- Used to program ESP32 microprocessor
- Attached to the CH340 USB-to-Serial chip
- Antenna Connector
- RP-SMA antenna connector for external antenna
- 1x Stemma QT/Qwiic terminal for I2C devices
- This connector is a JST SH – 1.0mm
- Pluggable screw terminals
- All screw terminals are 7.62mm, 5.08mm or 3.81mm pluggable style “rising clamp” terminals
- All with + (Philips head) screws
- Front (left to right seen from the front)
- 1x 7p 3.81mm Green Button input terminals
- 3x button pin
- All pulled high through debounce circuit, short to GND to trigger input
- 1x Generic GPIO
- 2x GND
- 1x 3v3
- 3x button pin
- 1x 2p 7.62mm Black Negative Power Input Terminal
- 1x 2p 7.62mm Red Positive Power Input Terminal
- 1x 7p 3.81mm Green Button input terminals
- Back (left to right seen from the front)
- 1x 2p 5.08mm Red positive power output terminal (fused at 6.3A per slot)
- 1x 5p 3.81mm Black dimming channel output terminals
- L1, L2, L3, L4 and L5
- 1x 2p 5.08mm Red positive power output terminal (fused at 6.3A per slot)
- 1x 5p 3.81mm Black dimming channel output terminals
- L6, L7, L8, L9 and L10
- 1x 2p 5.08mm Red positive power output terminal (fused at 6.3A per slot)
- 1x 5p 3.81mm Black dimming channel output terminals
- L11, L12, L13, L14 and L15
- Front (left to right seen from the front)
An-Penta-Deca comes delivered with all the terminal plugs included
[photo another shot of the board]