QuinLED Diff-Adv
3D printable cases

Back to QuinLED Diff-Adv main page

For the Diff-Adv system, as a bit of an experiment (and to better serve my customers), I’ve asked Samitha to design some high quality cases that don’t require any extra hardware then a 3D printer for each of the boards. After a few iterations I believe these turned out great and the STL files are available below to download the case and print for yourself!

The cases are designed with side extensions that allow you to screw them down or use a velcro strap to mount it down that way! If you do not want them you can either snip them off or modify it in your slicer to remove that part from the print.

In the future I also want to experiment with having pre-printed cases available through Allnet so you can choose to use the bare board or have a cases included for it in the same shipment, currently this option is not ready yet!

Below examples printed in JaYo Transparant PLA+ (red/yellow examples) or Kingroon PETG (blue/white examples).

Sender-4

Download the STL for the sender-4 here.

Receiver-Midpoint-1

Download the STL for Receiver-Midpoint-1 here.

Receiver-Midpoint-2

Download the STL for Receiver-Midpoint-2 here.

Some more case shots!