QuinLED-Dig-Quad Board Dimensions

This article applies to v1 boards, please see here for v2 dimensions!

For the people wanting to integrate the QuinLED-Dig-Quad into a case or make a 3D printed design for it, see the picture below the for the exact measurements of the board. You need to take about 3,5CM of height into account.

Since the v2r6b release the screw holes are M2.5 in size.

If you are looking to use a closed box, this is possible but please limit the amount of Amps running through the board. If you want to use the specified values (up to 30A) a vented enclosure is highly recommended!