Menu

QuinLED-An-Deca Soldering guide

Back to Index Page

The QuinLED-An-Deca was designed with hand soldering in mind and although you can use a hot air soldering while soldering some SMD components on it, it’s perfectly doable using a normal soldering iron.

If you have all the components you need to build a QuinLED-An-Deca, take a look at the following video to see how you can solder it together the easiest.

p.s. The video below was for the v1r5, since then the board has seen some small changes, please check the top of the current hardware guide and the revision history.

Just a word of extra warning because I didn’t make it 100% clear in the video:

 

Do NOT power up the board with the ESP32 on there before setting the DC-DC regulator to 5v!